• First remove the Existing USG from the site on the controller interface.

            This will force a factory restore on the old device.


  • Power on UXG and connect WAN interface to WAN port
  • Connect laptop directly to UXG Port 2 (RJ54)


DO NOT CONNECT TO LAN YET AS IT WILL DISH OUT 192.168.1.0/24 IP's on DHCP


  • HTTP to 192.168.1.1 


You should get a screen saying No Internet.


  • Select the Button to 'Configure'


  • First assign the Local Network IP address and DHCP Scope of your site 

(for example at Sandy Hill this would be 10.129.146.254 as the IP address and 255.255.254.0 as the Subnet. DHCP Start address is 10.129.146.20, DHCP End Address is 10.129.147.200).



  • Click Apply and wait for your for settings to take effect.

Your laptop should pick up DHCP on the new range you have specified.


  • HTTP to the new router IP Address (10.xxx.xxx.254) 


  • Click Configure again and this time set-up your ISP Settings either PPPOE or Static IP depending on your conenction.


  • Once Connected to the Internet Choose Next.


  • Name the Device (e.g. SANUXGPRO).
  • Accept the license Aggreement and choose Next.



The Next Page will ask for Login details for UI.com.

  • Click Skip on this step.



On the following screen we will manually configure the Adopition settings for our Controller.


  • Use the settings as below:



IP Address or Fully qualified domain name    =    wificentral.iaspire.net

Port           =    8443

Username =     Your personal Unifi Controller Login Details

Password =     Your personal Unifi Controller Login Details 

2FA          =     Your personal Unifi Controller Login Details 



On the next screen you'll have the drop down to select your site.

  • Choose your site from the list and adopt your device directly into your site.


The ISP and IP info will be taken directly from the UXG and used to overwrite the settings on the controller.


  • Remove your laptop from Port 2 and connect UXG to the switch using the Fibre Cable.


  • Go to the Controller interface and check Adoption was successful, Apply any pending updates if required.


Congratulations you have successfuly set-up and adopted your UXG Pro.


Post adoption check list


  • Confirm all AP's and switches check-in and report Online. 

Should any not appear you'll need to SSH to each device and run this command 

set-inform http://wificentral.iaspire.net:8080/inform


  • Check your DNS settings on the controller Internet page ares NOT set to Auto (Securly DNS = 3.10.73.55 + 3.10.96.65)


  • Check Site-to-Site VPN is UP


  • Run a speed test from the dashboard and update the ISP speed on the Internet Tab